
10-02-2012, 11:55 AM
|
 |
Junior Member
|
|
Join Date: Mar 2007
Posts: 5
|
|
wow ..this was really helpfull , to answer the question we do always meet together...
I will try it out that sounds very efficient and I of course would really like to go there to have bareback only......thanks for your support guys...
Quote:
Originally Posted by IG256
I think I found the solution for you.
I just tried an experiment. I heated the oven to about 250 degrees. I then took a condom still in the wrapper and put it on a glass pie tray on the middle rack. I checked it a 7 minutes and it was hot but still looked fine. I then put it back in for an additional 5 minutes - so 12 minutes total.
At 12 minutes, the outer wrapping was juuust beginning to wrinkle a little bit from the heat, so I took it out and let it cool off THOROUGHLY.
But with 12 minutes in 250 degree heat, I was betting that the rubber/latex/whatever would get weakened a lot.
After it THOROUGHLY cooled I put it on and began to masturbate. After about a minute or so of average to moderately aggressive masturbating...SNAP! It completely tore away at the tip!
That 12 minutes of heat at 250 degrees was enough to weaken the condom to make it break under "normal use" but not enough to deform the package to make it look like it was tampered with.
I suggest experimenting with different temps and times!
Also, if he is hung, maybe give him a smaller condom than he usually uses...
|
|